Anant Shot Blasting & Trading Co.

Garnet abrasive is a high-performance blast media that is commonly used for the cleaning of aluminium and fibreglass structures. It also has uses in water-jetting and can be used on sites where contamination is a concern such as applications close to watercourses.

This media is mainly used in applications in which a great impact force and “hammering action” is required to clean and in some cases also to peen a variety of steel and foundry products. 
The typical hardness of this media ranges between 40 – 61 HRC

Steel shot and grit are used in a surface preparation process for cleaning metal surfaces which are covered with mill scale, dirt, rust, or paint coatings and for physically modifying the metal surface such as creating roughness for better application of paint and coating.

White Fused Alumina is mainly used is as a recyclable abrasive in blast cabinets and blast rooms, where high purity of the abrasive is required. Because of its low iron content, white fused alumina is often used in blasting operations where iron contamination on the non-ferrous metal substrate is not allowed.

Glass Beads are a round, spherical media that produce a softer and brighter finish angular medias. Glass Beads are used for blasting, peening, honing, cleaning, and light deburring.

Steel Shot is manufactured by the atomization of molten steel followed by a series or thermal and mechanical treatments, to achieve the products final characteristics. The resulting spherical heat-treated special steel particles are uniform martensite and range from 0.3 to 2.8 mm diameter in size.

Steel Shot is manufactured by the atomization of molten steel followed by a series or thermal and mechanical treatments, to achieve the products final characteristics. The resulting spherical heat-treated special steel particles are uniform martensite and range from 0.3 to 2.8 mm diameter in size.

Aluminium has a density lower than those of other common metals, at approximately one third that of steel. It has a great affinity towards oxygen, and forms a protective layer of oxide on the surface when exposed to air. Aluminium visually resembles silver, both in its color and in its great ability to reflect light.

Aluminum Oxide Grit is a sharp, long-lasting abrasive media that is highly efficient and highly reusable/recyclable thus cost-effective in nature. Harder than most blast media, Aluminum Oxide Blast Media, the powder will clean and etch quickly on all types of surfaces. Grits of this abrasive media are best for preparing the surface for the polishing and coating of blasting surfaces. It is also used often for surface cleaning because of the rugged nature of this blasting media. The small grit particles and powder strike the area with compression and clean hard corners easily. Approximately it is 50% lighter weight blasting media than metallic media, aluminum oxide abrasive grain has twice the number of particles per pound. The fast-cutting action of aluminum oxide grit minimizes damage to thin materials by eliminating surface stresses caused by heavier, slower cutting media.